HOW DO I PAD THE SETS?
NOTE: You DO NOT have to pad them into sets to
use them. If the time between printing and distribution
is very short, many clients just paper clip or staple. Due
to the effort involved, we also do not recommend that you
pad less than one inch (1") of carbonless stock. If you
must pad a few sets, you can make the task easier if you
put and inch or so of standard copy paper on the bottom
of the stack. When you use the Carbonless Padding Adhesive,
the same coating that transfers the image will also make
the sets adhere to each other.
HAVE CARBONLESS QUESTIONS? |
Printing Video
|
Padding Video
|
Information is valid for All NCR Papers |
|
|
Jog
stack of paper by hand or machine. (Sheets
must smoothly align along the edge to
be padded.) |
|
|
Fold
a sheet of 8.5"x11" paper in 1/2 to
4.25" x 11" and lay it on a edge of
a table so that the fold is at the table's
edge. This will keep your table clean
(not shown). Place stack on flat surface
or in padding rack. (Edge to be padded
should not overhang support base.) Place
"weight-distribution board" on stack,
flush with edge to be padded. (Board
must be as wide or wider than edge to
be padded.) |
|
|
Place
weight on board to bring sheets into
contact with each other. (Use enough
weight to restrict paper separation
to about 1/8" when thumb is firmly run
down corner.) |
|
|
Saturate
the bristles with enough "Fanapart High-Strength
Padding Adhesive" for several strokes.
(Start with a dry, clean, 1-1/2" to
2" brush.) With a fully loaded brush,
apply adhesive to the entire edge to
be padded. (Start from the bottom center
of the stack stroking several times
outward to the edges, and work up.)
Repeat strokes in same area to ensure
1/8" adhesive penetration into the stack.
(DO NOT apply one "light" coat to the
entire area, then apply a second coat.) |
|
|
Let
Stand for 30 minutes before packaging.
(24 hours recommended before using.)
When dry, fan forms to separate sets. |
|