HOW DO I PAD THE SETS?
NOTE: You DO NOT have to pad them into sets to use them. If the time between printing and distribution is very short, many clients just paper clip or staple. Due to the effort involved, we also do not recommend that you pad less than one inch (1") of carbonless stock. If you must pad a few sets, you can make the task easier if you put and inch or so of standard copy paper on the bottom of the stack. When you use the Carbonless Padding Adhesive, the same coating that transfers the image will also make the sets adhere to each other.

HAVE CARBONLESS QUESTIONS?
Printing Video	Padding Video
Information is valid for All NCR Papers

	Jog stack of paper by hand or machine. (Sheets must smoothly align along the edge to be padded.)
	Fold a sheet of 8.5"x11" paper in 1/2 to 4.25" x 11" and lay it on a edge of a table so that the fold is at the table's edge. This will keep your table clean (not shown). Place stack on flat surface or in padding rack. (Edge to be padded should not overhang support base.) Place "weight-distribution board" on stack, flush with edge to be padded. (Board must be as wide or wider than edge to be padded.)
	Place weight on board to bring sheets into contact with each other. (Use enough weight to restrict paper separation to about 1/8" when thumb is firmly run down corner.)
	Saturate the bristles with enough "Fanapart High-Strength Padding Adhesive" for several strokes. (Start with a dry, clean, 1-1/2" to 2" brush.) With a fully loaded brush, apply adhesive to the entire edge to be padded. (Start from the bottom center of the stack stroking several times outward to the edges, and work up.) Repeat strokes in same area to ensure 1/8" adhesive penetration into the stack. (DO NOT apply one "light" coat to the entire area, then apply a second coat.)
	Let Stand for 30 minutes before packaging. (24 hours recommended before using.) When dry, fan forms to separate sets.